Fiat 500 Key Fob Replacement

If your 500 keyfob stops functioning, try another to determine if it will be detected by the car. If it does, the problem is most likely due to the original fob's battery, or water damage.

First replace the battery. The "+" side should be facing down.

Dead Battery

The majority of the time, when a fob isn't working it's because the battery is dead. This is easy to solve and most fobs give you a warning when the battery is failing. There are instructions on YouTube for nearly any car's key fob or look in the owner's manual. You can also change it by taking it to an authorized locksmith or Fiat 500 Key Fob Replacement a dealer who has sold it to you.

Sometimes, a fob won't functioning due to a malfunction in the internal circuit board. It's not often but it does happen. If you drop the fob onto something hard, it could damage the internal chip. It could also happen if you use an aftermarket fob and it doesn't work. In this scenario, you will need to go to an expert locksmith or dealer and have it reprogRammed to work with your 500.

One 2012 FIAT FIAT 500 flip key remote that resembles Ilco with locks, unlocks, and trunk buttons – new replacement keyless entry (will need to cut & program by a locksmith).

Damaged Chip

Fiat 500 key fobs are wireless devices that transmit a signal to the car whenever you press the button. It contains a microchip with details about the code required to communicate with your car. If the chip is damaged, it won't send the correct code, and the car will not start. It's possible to repair this type of damage and a locksmith will assist. United Locksmith can complete this service on both classic and newer models, so don't hesitate to call.

You can buy a new fob and have it professionally programmed by locksmiths. It's cheaper to do this rather than going to the dealer and works just as well. You'll need certain details to the locksmith, like the year your car was built and the model.

Rub the chip with an old dollar bill if not certain of what to do. The copper on the bill is abrasive enough remove oxidation and dirt, but won't cause any harm to the microchip. If the chip is physically damaged however, it may not be able to be repaired. This can happen if you fall it, ram it over by your vehicle or experience any other kind of physical strain.

Water Damage

If you've accidentally dropped your keys in the pool, put them in your bag while swimming at the beach or splashed them with water on a rainy day It's likely that your fob will suffer from water damage. Even if there's only a little water on the key, this can cause serious issues with its electronics and prevent it from working properly.

The good news is that you can often solve this issue by taking off the key fob and using the paper towel to cleanse it of any remaining dirt or water. After the fob is dry, you can then replace its battery and it will begin working normally.

You can also take it to an auto repair shop or Fiat 500 Key Fob Replacement locksmith to have it professionally cleaned and programmed. These professionals will use special equipment to ensure that the fob's key works with the car's computers.

If your Fiat 500's main fob stops working, it can be frustrating and stressful. It is tempting to go to the dealer to replace your key fob but this could be expensive and unaffordable. A locksmith can replace your key fob, without having to visit the dealership. Because of this, they are a far better choice than the dealership.

Pairing Issues

If you lose your key fob, or it stops working and nothing else appears to be going on there could be a chip that has gone off the rails. It could be due to water damage, a dead battery or it may be due to a need to reprogramme.

Most of the time, this can be accomplished by following the directions in your owner's guide. If you are having trouble or your manual isn't working and you need to have an automotive locksmith perform this task. This ensures the chip isn't damaged and is the cheapest solution.

Another problem with some 500 owners is that the key fob won't lock the car. This could be a problem if you want to fill up at the gas station. Some owners have complained that the locking system on their 500 has malfunctioned and they've needed to replace the entire intermediate steering shaft. This problem has actually been mentioned in a technical service bulletin (TSB) by Fiat.

A reputable locksmith is able to assist you if your Fiat is experiencing problems. They can duplicate your current key or make you a brand new one that locks and starts the vehicle. They can do this without seeing your old key, and is usually cheaper than purchasing one from the dealer.