Fiat 500 Replacement Key Fob

It may be time to change the battery if your 500 remote key fob isn't working. However, if you replace the battery but it is still not working it could be elsewhere.

United Locksmith specializes in the creation of new keys for classic vehicles. We have the tools as well as the parts required for this service.

Dead Coin Battery

A dead battery is the primary reason for your Fiat 500 keyfob not locking or unlocking the doors. The battery of the coin cell inside the key fob will deplete quickly if you don't use it frequently enough. If your remote is beginning to show signs like a loss in range or stopped functioning, then the battery may be dead.

The battery in the key fob is held in place with metal clips that retain it. If the clips aren't tightly secured, they could result in contact issues that prevent your remote to receive power. By using a small flathead screwdriver, pry the retaining clip to remove the battery and replace it with a new one. Be sure to choose a replacement with the same kind of voltage, size and specifications as the original battery.

The exposure to water can cause the key fob to corrode or be damaged. Even a quick bath in soapy, warm water could cause damage to the chip. It's best to keep your key fob in a dry place.

Water Damage

If your key fob doesn't work properly, it may be caused by water damage. Key fobs have rubber seals that prevent them from being damaged by rain or a splash of water, but it is very important to keep your keys away from the pool, ocean, and the washing machine!

The key fob comes with an electronic chip which sends a message to the immobilizer of your car. This is what allows your 500 to start or lock, but should the chip become wet, it can no longer function.

If you want to check whether your key fob still working you can clean the internal electronics with isopropyl or an electronic cleaner. However, it is probably recommended to purchase a replacement from a dealership rather than trying to fix an item that was submerged in salt water.

A replacement fob could cost you a bit, but it's a lot less expensive than paying to have your Fiat 500 towed to a dealership and fixed there! You can also fix it yourself by following only a few steps. Be sure to have the correct battery type before attempting to open your key fob. You can find step-bystep instructions for any car keyfob on the internet.

Faulty Chip

The chip in the key fob communicates with the immobiliser in your car to ensure that the vehicle will only start when correct keys are used. If the chip is damaged, or damaged in any way the car won't start.

Water damage or a dead cell phone battery are among the most common causes of defective chips. It is best to leave the job to a professional locksmith who can replace the chip in a short time and at a an affordable cost.

If your key fob ceases to function after exposure to clean water from the tap or rain, take out the battery and wipe down the electronic component with a tissue to ensure it's completely dry before putting it back in. If the key fob will not function, there's the possibility that it has malfunctioning components and need to be replaced.

Many people will seek out their dealer when they are in need of a new Fiat key fob, spacebohemian.com however this is a costly option. United Locksmith is the best choice if you want your Fiat keyfob repaired at a reasonable price. We have the tools and expertise necessary to repair your Fiat key fob in a timely and professional way.

Faulty Receiver Module

Fiat key fobs send a signal up 50 feet to the vehicle, which can unlock and close the doors (and start the vehicle for vehicles with automatic transmissions). However, there are some things that can cause the fob to stop working. It could be due to a dead battery, water damage, Thekeylab.co.uk worn buttons and a receiver module issue or signal interference, or an electronic chip that has failed.

If the fob was in a pocket which has endured extreme trauma, like being dropped on a hard floor or getting washed in a washing machine or dishwasher, it might not be able to communicate with the car's Body Control Module (BCM). This is because the BCM is an extremely secure system that will only accept a signal from a genuine key and not another.

If this is the case, you will require replacing your fob. A professional locksmith is able to handle all aspects of the replacement procedure and even program a new one for the 500. In fact, they could provide you with a replica key that functions exactly the same as the original fob (and costs a fraction of the price).